Centrometal CentroPelet ZV 20, Технические инструкции

Страница: 20 / 28

GB
Cleaning exchanger - stove off
Fouling act as insulation and the thicker they are, the
lower the heat that is transmitted to the water and to the
structure generally
. Therefore very important to perform
the cleaning of the tube bundle, said exchanger also, to
prevent the fouling of the same and prevent clogging and
jamming of the cleaning device
. Pull and push quickly for
5-6 times the lever so that the springs can remove the
soot deposited on the pipes.
Cleaning of painted pats
Do not clean the painted parts with wet rags when the
unit is in operation or hot to prevent thermal shock to the
paint which may cause it to detach. Do not use abrasive or
aggressive products or materials. Clean with damp cotton
or paper towels. The silicon paints used by manufacturer
possess technical characteristics that make them resistent
to very high temperatures. There is however a physical
limit (380° - 400°) beyond which the paint begins to fade or
(over 450°) to vitrify; it may then flake and detach from the
steel surface. If this happens, it means that temperatures
have been reached that are far above those at which the
unit should operate properly.
Check every 7 days
Clean bottom ash
from the fallen debris during operation .
You can access the ash pan by loosening the two wing
nuts that hold the drawer inspection
. Remove the tray,
empty and clean the wall and only the corners with a
suction device or with dedicated tooling
. Then mount the
drawer and tighten the two knobs being careful to restore
the tightness, very important during operation.
Check every 60/90 days
Cleaning the interior baffle / smoke fan compartment.
Inside the compartment where there is the ash tray,
there is a second cover, fixed by the cockerels, which
gives access to the compartment at the base of the duct
dedicated to the flue and the wall of the fume extractor
fan. Use a suction device for thorough cleaning of the
cabinet. Check the integrity of the seal in ceramic fiber.
Check every 2/3 days
Cleaning the ash collection compartment .
Clean and empty the ash tray being careful with hot ash.
The ash must be completely cold for a vacuum cleaner to
be used to remove it. Only if the ash is completely cold,
you can also use a canister vacuum cleaner suitable for
picking up particles of a certain size.
Cleaning ash and combustion chamber including the
spark plug lead
Cleaning the glass
For cleaning the ceramic glass, the use of a dry brush
is recommended, or if it is very dirty, the special spray
detergent, applying a small quantity then cleaning with a
cloth.
Cleaning of stainless steel and satin-finish surfaces
Normally these surfaces do not need to be treated, but
if they do, avoid cleaning them with abrasive materials.
For surfaces in stainless and satin brushed steel we
recommend cleaning with a paper towel or a clean dry
cloth moistened with a detergent based on non-ionic
surfactants (<5%) A spray glass cleaner may be used.
Do not use abrasive products and do not
spray the cleaning product on the glass of
the painted parts or on the gaskets of the
fire door (ceramic fibre cord).
Avoid contact with skin cleanser and eyes.
In case this happens, sprinkle with plenty
of water and contact the nearest medial
center.
Do not use abrasive materials or harsh.
Clean with damp cotton or paper towels.