Installation
5. The BOOST BASS button can be used to enhance the bass sound depending on your own music
preferences. Turn bass/boost effect ON simply by pressing the button, and pressing it once again
to OFF.
Remote Control Unit
1. Remove the battery cover at the rear of the remote control unit and insert 2 “AAA” size batteries
(not included) into the battery compartment with the correct polarity.
2. Replace the cover to close the battery compartment.
Note
You should now be able to move the speakers freely from room to room without disruption. If
disruption should occur (signal breaks up), press the speaker’s AUTO SCAN button to maximize
the best reception. If you hear interference from other components, switch the channel control of the
transmitter, and then move the speakers to another free location. You can re-adjust the tuning control
by moving it either to channel 1 or 2 of the transmitter, then pressing AUTO SCAN button for the best
reception. When transmitting / receiving over long distances, the signal from the system will
become weaker.
Switching Off
1. For protection of the transmitter and for power saving, the transmitter will cut off automatically if
there is no or weak operation input signal from audio source for 4 minutes.In other words, if the
signal comes back, the transmitter will work again automatically.
2. Press the POWER button to turn off the speaker and the blue POWER LED light will go off. If you
use the remote control unit to turn off the speakers, the speakers will be at stand-by mode for 5
minutes and the LED will change from blue to yellow. You can switch on the speakers again by
using the remote control unit during stand-by time. If there is no signal from the remote control unit
for 5 minutes, the speakers will automatically power off.
5
