Central Machinery 43389, Руководство пользователя

Страница: 9 / 16

Page 9 For technical questions, please call 1-888-866-5797. Item 43389
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
TO pREVENT SERIOUS INJURy: DO NOT OpERATE WITH ANy GUARD DISABLED,
DAMAGED, OR REMOVED. Moving guards must move freely and close instantly.
Setting the Depth Scale to Drill to a Specified Depth
Locking
Switch (15)
Switch Key (18)
Rocker (light)
Switch (17)
Depth
Screw
Lock (6)
Depth Stop
Ring (5)
1. Secure the workpiece to the Table.
2. Mark the desired hole depth on
the side of the workpiece.
3. Loosen the Depth Screw Lock (6).
4. Turn the Feed Handle counterclockwise to bring the
tip of the drill bit down, next to the hole depth mark.
5. Turn the Depth Stop Ring (5)
counterclockwise until it stops moving.
6. Tighten the Depth Screw Lock.
Locking the chuck at a Specific Depth
1. Loosen the Depth Screw Lock.
2. Turn the Feed Handle counterclockwise to
bring the Chuck to the desired depth.
3. Turn the Depth Stop Ring clockwise until it stops.
4. Tighten the Depth Screw Lock.
The Chuck will be held at this position
when the Feed Handle is released.
Tilting the Table
1. Loosen Set Screw (B1) with the Hex Key.
2. Loosen the Machine Screw (B8)
with the Wrench (B20).
3. Rotate the Table to the desired angle.
The scale can be used to approximate the angle.
4. Retighten the Machine Screw, then the Set Screw.
Using cutting Oil Drip System
1. Add the desired cutting oil to the Oil Bottle (52).
2. Adjust the feed segments to allow the
oil to drip onto the cutting area.
3. The used oil will collect in the Oil Bottle
attached to the underside of the Table.
• Before the Bottle is full, dispose of the used
oil in accordance with local regulations.
Bit Installation
1. Insert the bit into the jaws of the chuck
approximately 1″, ensuring that the jaws
do not touch the flutes of the drill.
2. Ensure that the bit is centered within
the jaws, then use the supplied chuck
key to firmly tighten the chuck.