Page 6
For technical questions, please call 1-888-866-5797.
Item 43389
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
Specifications
Motor
120VAC, 60Hz, 13.5A
1720 RPM
Spindle Speeds
200, 290, 350, 430, 500, 580, 640, 720, 800, 870,
1440, 1630, 1820, 2380, 2540, and 3630 RPM
Spindle
Stroke: 3-1/8"; Taper: MT2
Column
Ø 3.15 (diameter) inches;
Head to base: 50-3/4"
Chuck to base: 45-1/2"
Chuck to table: 25-1/4"
Base Dimensions
13-1/2" x 20-1/4"
Chuck Capacity
1/8" to 5/8"; Taper: JT3
Table Slot
1/2" x 4"
Table Rotation
360°; Tilt: 45° (left and right)
Table Size
14" x 14"
Features
Oiler with flex-tube, and lamp
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical
outlet before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Mounting
Secure the tool to a supporting structure before use.
Before assembly, bolt the Base to a flat, level,
solid floor location capable of supporting the
weight of the drill press and any workpieces.
Verify that installation surface has no hidden
utility lines before drilling or driving screws.
Assembly
1. Place the
column Tube
(B14) on the Base,
aligning the mounting holes.
2. Insert four large Machine Screws (B12) into the
mounting holes and tighten with a wrench.
Machine Screws (B12)
Column Tube (B14)
3. Install the
column clamp
(B16) on the left side
of the Table Support (B17). Hand Tighten.
Column Clamp (B16)
