Page 20
SKU 97816
For technical questions, please call 1-800-444-3353.
Lever (9) to lock the Rip Fence in
place.
(See Figure V, next page.)
Place the workpiece on the Table Saw
4.
and firmly against the Fence Board (2)
of the Rip Fence (1 thru 17) assembly.
(See Figure V.)
Plug the Table Saw’s Power Cord into
5.
the nearest 220 volt, grounded, electri-
cal outlet.
Press the
6.
“ON”
Button on the Power
Switch (501) to turn on the Table Saw.
(See Figure L.)
When the Saw Blade is turning at full
7.
speed, slowly push the workpiece into
the Saw Blade. Do not force the Saw
Blade to remove material faster than
it is designed to cut. Use a push stick
when required.
Never attempt to remove material
8.
stuck in the moving parts of the Table
Saw while it is plugged in and running.
Turn off the Table Saw if the workpiece
9.
is to be backed out of an uncompleted
cut.
When the cut is complete, press the
10.
“OFF” Button on the Power Switch
(501) to turn off the Table Saw.
(See Figure V.)
FIgurE V
rIp FENCE ASSY.
(1 THr 17)
FENCE BOArd
(2)
LOCK LEVEr
(9)
11. Wait until the Saw Blade comes to
a complete stop. Then, unplug the
Power Cord from its electrical outlet.
Remove the cut workpiece and de-
12.
bris from the Table Saw.
To use the Miter gauge Assembly
WArNINg!
1.
When using the Miter
Gauge (401 thru 419) assembly,
always keep hands and fingers well
away from the Saw Blade and cutting
area.
Set the Miter Gauge (401 thru 419)
2.
assembly on the left Extension Wing
(127) of the Table Saw.
(See Figure W.)
Operate the Miter Gauge (401 thru
3.
419) by loosening the Knob (418),
and turning the Miter Gauge Body
(408) to the desired angle of cut.
Tighten Knob (418).
(See Figure W.)
Place the workpiece on the Table
4.
Saw and firmly against the Miter
Gauge Body (408).
(See Figure W.)
