Page 16
SKU 97816
For technical questions, please call 1-800-444-3353.
AdjuSTMENTS
To Adjust the Splitter and Blade
guard Assembly
Set a machinist’s square against the
1.
face of the Splitter (311). Slightly ro-
tate the rear bracket to adjust the face
of the Splitter perpendicular to the
Table (126).
(See Figure M.)
FIgurE M
MACHINIST’S SQuArE
(NOT INCLudEd)
SpLITTEr
(311)
2. Raise the Blade Guard Assembly
away from the Table (126) and hold
the anti-kickback Pawls (308) away
from the Table surface.
(See Figure N.)
Using an accurate straight edge, align
3.
the Splitter (311) with the Saw Blade.
Make sure the straight edge rests
against the side of the Saw Blade.
(See Figure N.)
FIgurE N
SpLITTEr
(311)
STrAIgHT EdgE
(NOT INCLudEd)
4. If the Splitter (311) is to the right of
the Saw Blade, add washers between
the Splitter and the front mounting
bracket. Then, adjust the rear Splitter
support.
(See Figure O.)
5. Recheck the Splitter (311) alignment
to the Saw Blade and to the Table
(126) top. Adjust as necessary, and
tighten all loose bolts before use.
NOTE: If the Splitter (311) is posi-
6.
tioned to the left of the Saw Blade,
alignment cannot be achieved by add-
FIgurE O
