Page 13
SKU 97816
For technical questions, please call 1-800-444-3353.
FIgurE F
duST
pOrT
(124)
CLEANOuT dOOr
(118)
dOOr LATCH (119)
KNOB (120)
FLAT WASHErS (121)
ELASTIC WASHErS (122)
NuTS (123)
To Attach the Front and rear
rails
Align the mounting holes in the Front
1.
Rail (23) with the mounting holes on
the front edges of the left Extension
Wing (127), Table (126), and right
Extension Wing (127). Use four Bolts
(27), four Elastic Washers (26), and
four Flat Washers (25) to secure the
Front Rail to the left Extension Wing,
Table, and right Extension Wing.
NOTE: Make sure the top of the
Front Rail is flush with the top of the
left Extension Wing, Table, and right
Extension Wing.
(See Figure g.)
Repeat Step #1 above to attach the
2.
Rear Rail (24) to the rear edges of
the left Extension Wing (127), Table
(126), and right Extension Wing
(127).
(See Figure g.)
FIgurE g
BOLT (27)
ELASTIC WASHEr (26)
FLAT WASHEr (25)
To Attach the Hand Wheels
Line up the Key (217) on the
1.
Angle
Shaft (218) with the keyway slot in the
Hand Wheel (202), and slide the Hand
Wheel onto the Shaft.
(See Figure H, next page.)
Tighten the Set Screw (203) on the
2.
Hand Wheel’s (202) hub to hold the
Hand Wheel securely in place.
(See Figure H, next page.)
Install the Hand Wheel Lock (201) into
3.
the center hole of Hand Wheel (202)
by rotating in a clockwise direction.
(See Figure H, next page.)
Install the Handle into the Hand Wheel
4.
(202) by inserting the Handle into the
cavity at the edge of the Hand Wheel
and threading in a clockwise direction.
(See Figure H, next page.)
Repeat Steps #1 through #4 above
5.
for the remaining Hand Wheel (202),
Height Shaft (245), Hand Wheel Lock
(201), and Handle.
(See Figure H.)
