CentoLight ZEPHIRO FOG 900, Руководство пользователя

Страница: 9 / 28

9 9
Zephiro Fog 900 User Manual
Eng
1. On/off switch
2. Remote Control receiver /Manual
Control connector
3. Power inlet (IEC connector)
4. Fuse
5. Warm Up Indicator
6. Fluid level indicator
7. Liquid hose and liquid tank cap
4 - P
roduCT
o
vervIew
4.1. Mains Power & Fuse
Power Inlet (3) - In case of loss or replacement of the cable, refer to the following
table which shows the correspondence of the internal wires:
Cable (EU) Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth must to be connected! Pay attention to the safety! Before taking into
operation for the first time, the installation has to be approved by an expert.
Fuse Holder (n.4) - In case you need to replace the fuse, make sure that the appli-
ance is switched off, disconnect the input power plug, and unscrew the fuse holder
cover shown above with a Phillips screwdriver.
CAUTION: Replace the fuse ONLY with one of the same type indicated in the sec-
tion “8 - Specification” on page 13 (T10A/250V - 5x20 mm). A lower value
fuse would blow immediately after the first power on; a higher value would not
act as a fuse in case of anomalous current absorption or short circuit.
WARNING: Always connect the product to a protected circuit (with circuit break-
er). Make sure the machine has an appropriate electrical ground to avoid the
risk of electric shock or fire.
WARNING: Never connect the Zephiro Fog 900 to a rheostat (variable resistor)
or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to
100 % switch.
5 - s
eTTIng
u
P
y
Zephiro FOG 900 can be installed in high places (with clamps or couplers, not
included), or placed on the ground.