CentoLight ZEPHIRO FOG 900, Руководство пользователя

Страница: 11 / 28

11 11
Zephiro Fog 900 User Manual
Eng
1) Wireless remote control
Once warm-up is complete, press A or B button to start fog emission. By pressing
them long time, you can spray fog long time till the unit will warm up again. By re-
leasing buttons, it stops spraying).
2) Wired control
Connect the controller to the machine rear panel through MANUAL CONTROL con-
nector.
1. Manual fog switch: Fog projection when pressed.
2. Red LED - Warm Up Indicator.
3. Green LED - Fog Machine Ready.
6.2. Wireless Remote Battery Replacement
If the remote control cannot work (red LED does not lit and machine does not oper-
ates), please check whether battery is low and need to be replaced.
To change the battery, remove the cover on the back of the remote control and
replace the old battery with one of the same type (23A - 12V).
ATTENTION: Pay attention to respect the polarity. The two ends of the battery
have a “+” (positive pole) and a “-” (negative pole) respectively. These marks are
also present inside the battery compartment. Make sure the “+” of the battery is
towards the “+” indicated in the battery compartment.
7 - C
orreCT
u
se and
M
aInTenanCe
This fog machine should be used in dry and well-ventilated place . Please avoid any
water or rain fall in the machines, if water and rain fall in, turn off the power immedi-
ately. Keep far away from children, fire, explosive and flammable things, and avoid
scalding.
NOTE: In the first time use, some liquid might spray out. This is normal.
y
When liquid is getting low, please add it again in time. If the fog machine works
without fluid for a long time, its pump and other parts could get damaged.
When adding fluid, remember to turn power off, and carefully avoid spilling over
to cause short circuits.
y
The fog machine should work under professional operator’s supervision, please
do not add flammable liquids or gas into the fog fluid tank.
y
When you don’t use the machine for long time or after use, please disconnect
power or unplug the power cable. After using, please wipe out the liquid in the
tank, as it would avoid the housing to be corroded.