8
This section shows you how to setup and run the thermostat in 3 simple steps:
STEP 1: Installing the Batteries
Note:
Please follow the instructions in this section only if the thermostat screen is
blank (no symbols or digits are displayed). If the room temperature is already displayed
move on to
Step 2: Setting the Date and Time
.
To install the Batteries:
a.
Lift up the front cover of the thermostat to reveal the battery cover and product
controls.
b.
Remove the battery cover by pressing down and sliding out.
c.
Insert the 2 x AA LR6 Alkaline Batteries supplied with the thermostat, ensuring the
correct orientation (see ‘
Controls Layout
’ on page 2).
d.
After a short pause the thermostat will display information on the screen and is now
ready for use.
e
. Replace the battery cover by sliding it firmly back into the front of the thermostat.
STEP 2: Setting the Time
To set the Date and Time:
a.
Press the
DAY
button once and the ‘day indicator’ will begin to flash.
b.
Press the
DAY
button until the correct day is reached (Day 1 = Monday). Press the
button to confirm.
d.
Press either of the or buttons once to enter time setting mode. The LCD
screen flashes the time digits (when the unit is powered for the first time the display
shows 12:00).
e.
Use the or buttons to set the correct time then press the
button to
confirm. Each press of the buttons will change the time by one minute and holding
them down will change the time slowly at first and get progressively quicker.
Note:
If this mode is entered accidentally then press the
AUTO
,
MAN
or
OFF
buttons to exit.
STEP 3: Running the Built-in Heating Program
The thermostat is now ready for operation. Press the
AUTO
button and the built-in
heating program will start running.
Note:
The built-in heating program has been designed to provide normal comfort
requirements, but if you want to customise the settings please see the next section
‘
Programming the EHE0200154
’.
Setting-up the EHE0200154
