5
To disable or enable time periods:
a.
To disable unwanted periods go to the desired period (
2
to
4
) using the
PROGRAM
or buttons to navigate, ensure the correct period is highlighted
with the flashing square symbol. Press and hold the button for at least 2 seconds
and the display will indicate the period has been removed from the program.
b.
To enable periods again follow the same procedure as above, navigating to the
already disabled period. To enable this period again press and hold the button for
at least 2 seconds.
Operating the EHE0200153
Choosing the Operating Mode
The thermostat can operate in three different modes: Automatic, Manual or Off. To
set the operating mode press either of the
AUTO
,
MAN
or
OFF
buttons. The screen
indicates which mode is currently active by displaying
AUTO
,
MAN
or
OFF
.
•
AUTO (automatic)
mode sets the thermostat to follow the built-in temperature
program (default or personalised). Operating the thermostat in this mode is the best way
to maintain a high level of temperature comfort whilst maximising your energy savings.
•
MAN (manual)
mode sets the thermostat to act as a simple thermostat with a
fixed setpoint throughout the day. The setpoint can be adjusted from 5°C to 35°C
by using the or buttons. The thermostat will continue to maintain this
temperature until another operating mode or temperature is selected.
•
OFF
mode sets the thermostat to control to a minimum temperature setting of 5°C
(default) that acts as a frost protection measure for your home.
During Normal Operation
•
Temperature Enquiry
In
AUTO
,
MAN
and
OFF
operating modes the thermostat will display the current
room temperature. To review the programmed ‘target’ temperature (the temperature
which the thermostat is trying to maintain) press the button. This ‘target’
temperature value will be displayed flashing for 5 seconds before returning to the
current room temperature value.
•
Temperature Override
During normal operation (
AUTO
mode) the programmed temperature can be
adjusted manually by pressing the or buttons or the button. The ‘target’
temperature will be displayed and flash for 5 seconds - during this time the or
buttons can be used to modify the set value.
Note:
This temperature override is cancelled at the next programmed temperature change.
Adjusting the Time
To adjust only the time during normal operation use the or buttons to adjust
the time and press the
button again to confirm any changes.
