4
– Use this tool for its intended purpose only.
– Inspect tool before use, replace any worn or damaged parts.
– Inspect pump hydraulic hoses and couplings before each use.
– Clear work area.
– Operating & Safety procedures may vary in accordance with the working guide lines
established by each utility or contractor.
– For your own safety, ensure that you fully comply with all “safe operation” practices required
by your employer.
– To protect from ELECTRICAL SHOCK HAZARD, always wear the necessary cloting & equipment
and follow the required safety practices.
Failure to follow these rules may result in serious personal injury or death.
– Before connecting or disconnecting the presshead always disconnect pump / power source
and switch to OFF.
– Before connecting the presshead always inspect hoses and couplings.
Always wear eye protection to avoid injury from flying debris or hydraulic oil leaks.
– To avoid tool damage or severe injury, worn or leaking parts must be repaired or replaced,
leakage is a sign of deterioration in component parts.
GENERAL SAFETY
1. GENERAL CHARACTERISTICS
–
Application range:
suitable for installing compression sleeves and lugs on ACSR and ACAR full
tension, substation and transmission connections.
–
Supply:
Operable from a single or double acting 10,000 psi hydraulic power source.
–
Crimping force:
................................................................................................. 1100 kN (123 sh ton)
–
Max. operating pressure:
............................................................................. 700 bar (10,000 psi)
–
Oil necessary
(displacement)
:
...................................................................... 462 cm
3
(28.2 cu.in.)
–
Ram stroke:
......................................................................................................... 30 mm
(1.18 in.)
–
Weight:
(without dies)
.....................................................................................
50,7 kg
(111.5 lbs)
–
Dimensions:
....................................................................................................... Ref. to page 15
–
Type of dies:
RHU1000 presshead can accepts most 100 ton semi-circular type dies currently
used with Alcoa, Burndy, and other 100 ton presses.
