3
HYDRAULIC PRESSHEAD
RH50
1. GENERAL CHARACTERISTICS
– Application range:
the head is suitable for compression of electrical connectors on conductors
up to .............................................................................................300 mm
2
(600
MCM)
– Crimping force:
................................................................................................................50 kN
(6 sh ton)
–
Max operating pressure:
.............................................................................................700 bar
(10,000 psi)
– Oil necessary
(displacement)
:
....................................................................................13 cm
3
(0.8 cu. in)
–
Dimensions:
length ........................................................................................................196 mm (7.7 in.)
width .........................................................................................................75 mm
(3 in.)
–
Weight:
(without dies) ...................................................................................................1,6 kg
(3.5 lbs)
2. INSTRUCTIONS FOR USE
(Ref. to Fig. 2)
2.1) Setting
The head is equipped with a “self-lock” quick male coupler suitable for connection to a hydraulic,
pneumatic or electrical pump from the
Cembre
range.
2.2) Die insertion
– Select the appropriate die set for the connector.
– Open the latch (13) and release the upper die holder (12).
– Insert one die into the upper die holder (12) and one die into the lower die holder (19).
– Close the latch.
Ensure that the latch and the upper die holder are fully secured, otherwise damage may occur
during tool operation.
2.3) Die advancement
– Insert the conductor into the connector.
– Locate the connector between the dies at the desired crimp position.
– Operate the pump to advance the main ram (07).
Make sure that dies are exactly positioned on the area to be crimped; otherwise, re-open dies fol-
lowing instructions as per § 2.5 and position the connector again.
ENGLISH
