12
07
18
STOP THE ENGINE when servicing the drill: before removing the broach
cutters, spiral bits, positioning templates etc.
6.1) Assembling broach cutters
(Ref. to Figs. 8-11).
6.1.1)
Insert the guide bit in the cutter from the side of the spigot.
6.1.2)
Using the lever (36), position the spindle shaft (07) so that both grub screws (18) become
accessible and sufficient space is provided to insert the cutter; if necessary rotate the
spindle shaft manually and sufficiently by inserting the 4 mm allen key in the appropriate
intermediate gear housing (33) in the crankcase of the drill (see Fig. 11).
6.1.3)
Insert the cutter in the spindle shaft so that the two engaging dogs on the cutter spigot
line up with the grub screws (18).
6.1.4)
Clamp the cutter by fully tightening the grub screws using the 4 mm allen key.
6.1.5)
Check that the guide bit slides freely by applying slight pressure on it.
FIG. 8 – ASSEMBLING BROACH CUTTERS
6.2) Assembling special spiral bits
(Ref. to Figs. 9 - 11)
6.2.1)
Using the advance lever, position the spindle shaft so that both grub screws become
accessible and sufficient space is provided to insert the spiral bit; if necessary rotate the
spindle shaft manually and sufficiently by inserting the 4 mm male hexagon key in the
appropriate intermediate gear housing (33) in the crank-case of the drill (see Fig. 11).
Short type broach cutter
Maximum drilling thickness: 25 mm
Guide bit PP...
Long type broach cutter
Maximum drilling thickness: 50 mm
Guide bit PPL ...
Engaging dogs
6. PREPARING THE DRILL