Cembre B35-45MD, Руководство по эксплуатации и обслуживанию

Страница: 5 / 36

5
ENGLISH
2. INSTRUCTIONS FOR USE
2.1) Preparation (Ref. to Figs. 1, 2)
With the tool in the rest position, proceed as follows:
– Select the appropriate die set for the connector.
– Open the latch (25) and release the upper die holder (24).
– Insert one die into the upper die holder (24) and one die into the lower die support
(33).
For indent crimping, the nest MA... must be inserted in to the upper die holder (24),
and the indentor PA... must be inserted into the lower die support (33).
– Close the latch (25).
– Insert the conductor in
the
connector.
– Position the connec tor
bet ween the dies and
ensure the correct loca-
tion of the crimp.
Ensure that the latch
and the upper die hol-
der are fully secured,
otherwise damage may
occur during tool ope -
ration.
2.2) Die advancement
– Grip the tool fi rmly and comfortably and press the operating button (4) to activate the
motor-pump and advance the lower die. To halt the advancement, release the operating
button (4) and the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp point otherwise
re-open dies following instructions as per § 2.4 and reposition the connector.
2.3) Compression
– By keeping operating button (4) pressed, the motor continues to operate: the ram will
gradually move forward until the two dies touch.
It is recommended to keep operating until the maximum pressure valve is activated and
a "click" is heard.
– The motor will continue to operate after the maximum pressure relief valve has activated.
No further crimping force is applied, the oil is bypassed and returned to the reservoir.
FIG. 2
24
33
25
PA ...
MA ...