Cembre B1350L-C, Руководство по эксплуатации и обслуживанию

Страница: 11 / 48

11
ENGLISH
To make a selected screen operational and appear at each start
up of the tool, operate the touch button for at least 3 seconds; a
continuous beep will confi rm the setting.
The capacitive menu selection button may not work if touched using objects or
when wearing gloves, therefore always operate it using a bare fi nger.
4.2)
SELECTION SCREENS: control parameters that cannot be set as automatic upon
start-up of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights (factory setting LED ON)
When the screen is dis-
played, touch the button for
at least 3 seconds to deacti-
vate for reactivate operation
of the LED Worklights during
tool use; a continuous beep
will confi rm the setting.
Return to original factory settings / fi rmware version
When the " RESET " screen is displayed, return the tool to its factory setting by operating
the touch button for at least 3 seconds; a beep will confi rm the setting.
The RESET screen also shows the fi rmware version of the circuit board.
4.3)
WARNINGS: these appear during operation and notify the operator of the status of
the tool:
LED
OFF LED
ON
LED
OFF
3 SEC.
LED
ON
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to
Cembre
for a complete overhaul (see § 6).
NOTE: this message, together with a beep, will reappear when the tool has been
idle for 30 seconds.
30001
3
BATTERY
Ï
Ð
Ï
Ð
BATTERY
Ï Ð
RESET
SW:S1J41AH
3 SEC.