CEMB DWA1100, Руководство по эксплуатации и обслуживанию, Страница: 15 / 62

13
1
3 4 5/6
7
8
10 9
11
12
15
16
17
14
18
19
20
2
13
►
3.2 - Settings
To access this page from the home page press

and then

.
The following parameters can be set:
1. Time of inactivity after which the measuring heads
go into standby to reduce battery consumption
(infrared LEDs off).
2. Language
3. Format of the fractions of an angle
• '/100 (dec) = hundredths of a degree (centesi -
mal degrees)
• °/60 (min) = sixtieth of a degree (sexagesimal
degrees)
4. Angle resolution shown on the display (the actual
resolution of the instrument does not change)
5. Toe-in format and resolution
• '/100 °/60 = degrees, resolution specified in box 6
• mm = millimetres, resolution specified in box 8
• inch (dec) = inches, resolution in tenths of an
inch
• inch (1/4) = inches, resolution in fourths of an
inch
• inch (1/64) = inches, resolution in sixty-fourths
of an inch
6. Toe-in resolution if expressed in millimetres or
inches
7. Distance unit of measure
8. Type of communication between the measuring
heads and the computer ('Cable' = via cable) 'BT'
= Bluetooth; 'BT2' = Second generation Bluetooth)
9. Type of runout permitted ('UP/DOWN' = both lifted
and on the ground; 'UP' = lifted only; 'Bypass' =
runout execution not required)
10. Enables checks on correct runout execution
11. Help texts:
• OFF: disabled
• ON: displays on the screen buttons their name
• ON+INF: displays the previous and pages titles
12. Settings page password ('ON' = password required
to access the Settings page)
13. Number of alignments executed
14. Car database active
15. Truck database active
16. COM port setting
do not change (reserved for
technical service).
17. In IBRIDA or HYBRID mode (
*
): measurements made
with all the sensors (8 sensors) or disabling the rear
toe-in sensors (6 sensors). This second setting is
useful in order to be able to make a measurement
also if the rear toe-in radius is interrupted.
*
The
measurement execution mode requires the use of
2 CAR sensors and 2 TRUCK sensors.
18. ( ) Level sensor tolerance. Select the 'Normal'
setting to optimise measurement accuracy. Use the
'Wide' setting only if you have difficulty keeping
the measuring heads level, for example, when
measuring with the engine on
19. Option to disable caster measurement:
ON: steering required
OFF: steering not required
20. Aut omatic next page for the brake pedal lock and
steering lock positioning pages
AUTO ON: the next page is automatically displayed
after 15 seconds
AUTO OFF: you need to press F6 to go to the next
page