Cellink INKREDIBLE, Руководство пользователя

Страница: 60 / 68

60
3. Use the following sequence to fine tune the hight of the printheads:
-Adjust set screw on the right side of printhead 2.
-In the “Utilities Menu”, select “Home printheads”.
-In the “Utilities Menu”, select “Raise printheads”.
-Control if the printheads is completely level. If not, repeat the sequence.
8.2.8 Display flickering or displaying random characters
The issue is most likely electrical interference from the air compressor. To fix this, do the
following:
1. Turn off the INKREDIBLE 3D Bioprinter and the air compressor.
2. Disconnect the air compressor from the power outlet.
3. Connect the air compressor to a power outlet running on a different fuse.
4. Turn on the INKREDIBLE 3D Bioprinter and continue bioprinting.
8.2.9 Control knob is not responding when pressed
The issue is most likely that the knob was pushed all the way in, so it’s already in the
“click”-position. To correct this, pull the knob gently towards you.
8.2.10 Printhead 1 is missing the probing sensor at the end of the “Home Axes”-
sequence
At the end of the “Home Axes” sequene, the nozzle in PH1 touches the probing sensor
attached to the printbed to calibrate the nozzle length. If the nozzle misses the probing
sensor, then the probing position must be corrected to continue with the calibration
process. Follow these steps to find the probing position for each axis:
1. Navigate to the “Utilities Menu” and enter by pressing the control knob [8].
2. Select HOME AXES and let the INKREDIBLE 3D Bioprinter carry out the
sequence. If printhead 1 does not trigger the probing sensor, trigger it
manually by hand by pressing the sensor 3 times when the needle is about
to touch the sensor.
3. Adjust the Z position of printhead one until it is right above the probing
sensor by following these steps:
-In the “Utilities Menu”, select “Move Axis” and enter by pressing the
control knob [8].
-Turn the knob to job the Z-axis to position Z+5.0 (The position for each axis will
be written in the LCD display).