CellarPro 4000Shwc, Руководство пользователя

Страница: 43 / 43

43
V10.19
CellarPro Split Systems must be installed by an experienced professional in adherence with industry practices
and as described in the manual. If you need technical assistance during the installation, call 877.726.8496 x2.
Tech Name: ____________________ Tech Phone: ______________ Date of Measurement: _____________
System Information Piping Information
MM/DD/YY
Customer Name
R-134a System Charge
(lb)
Condensing Unit Model # Line-set Length (ft)
Condensing Unit Serial # Liquid line diameter (OD)
Evaporator Model # Suction line diameter (OD)
Evaporator Serial #
Trap installed in drain line,
charged with water, and
tested for drainage (Y/N)
Operation Start Date
Power to Condensing Unit (Check One) ____ From Evaporator ____ From External Source
Initial Refrigerant Charge Through (Check One) ____ Suction Access Valve ___ Liquid Access Valve
Operational Data:
Take the following measurements during a normal refrigeration cycle, once the cellar has pulled down
to the set-point temperature. Make sure the compressor is running when recording the data
.
Evaporator Range
Air temp. at Evap coil (°F) Inlet Outlet TD 8-10°F TD
Evaporator power supply Volts Amps
103-127V /
Nameplate Amps
Condensing Unit
Water temp at Condenser coil (°F) Inlet Outlet
In: 75°F /
Out: 95°F Max
Water Inlet Pressure PSIG 125 PSIG Max
Suction readings access valve PSIG °F SH
25-35 PSIG /
20°F Min.
Superheat
Liquid readings at access valve PSIG °F SC
150 PSIG Max /
8-12°F Subcooling
Condensing unit power supply Volts Amps
103-127V /
Nameplate Amps
odS Setting
Please provide the email address
to contact with the warranty
activation:
* * R E Q U I R E D * * TO ACTIVATE THE WARRANTY.
INSTALLERS
MUST
FILL OUT THIS SHEET AND FAX TO
707.794.8005 OR SCAN & EMAIL TO INFO@CELLARPRO.COM