CellarPro 4000Shwc, Руководство пользователя

Страница: 27 / 43

27
V10.19
b. Release when the display starts blinking.
c. Quickly repeat the same process – ie press and hold the "SET" and
"DOWN ARROW" buttons AT THE SAME TIME, this time for 7 seconds
("Pr2" will briefly flash on the display).
d. Using the "UP ARROW" or "DOWN ARROW" button, scroll through the
parameters until "odS" is displayed.
e. Press "SET" and change the setting to 30.
f. Press “SET” to accept the change.
Installation Tips and Guidelines

Make sure all electrical connections are secure.

Inspect Evaporator fan(s) to confirm airflow. There shouldn’t be any excessive
vibration, noise or obstructions to airflow.

Observe system pressures and temperatures during charging and initial
operation and keep note of them as they will be required for the Service and
Support Data Sheet which initiates the warranty.

Do not overcharge or use refrigerant with additives.

Remember that bubbles in a sight glass may be caused by a restriction as well
as a shortage of refrigerant. A properly charged system may still have small
bubbles visible in the sight glass, so use actual superheat and subcooling
readings to charge the system.

Do not leave unit unattended until the system has reached normal operating
conditions, and the system has been observed properly cycling on/off to the
desired set point and differential.

Make sure all access valve caps are in place and tight.