Use caution when lifting and check the package for damage.
Lift only at the designated hand-hold locations on the shipping container, or fully support the unit from underneath. A
shipment may include one or more boxes containing accessories.
Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
Note any discrepancies or visual damage on the bill of lading before signing.
Sit unit upright for 24 hours.
Review the packing slip to verify contents.
Check the model number to ensure it is correct.
Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information,
contact
CellarCool
Customer Service immediately.
RECEIVING & INSPECTING THE SYSTEM
Upon receiving your
CellarCool
unit:
NOTE:
CellarCool units are manufactured in
the USA and tested prior to shipment.
Verify that the pallet you’ve received contains the following:
(1) Evaporator box
(1) Square-to-round plenum box
(1) Condensing unit box
2.
Verify that the condensing unit box contains the
following:
(1) Magnum 9000 H.E. condensing unit OR
(1) Magnum 12000 H.E. condensing unit (depending on unit
ordered)
3.
Verify that the square-to-round plenum box contains the
following:
(1) Square-to-round plenum
(8) #10-16 x 1/2” steel drilling screws
Pictured:
9000 condensing unit
Please leave the unit in its original box until you are ready for installation. This will allow you to move the product safely without
damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP:
Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
Pictured:
Magnum evaporator unit
Documentation bag:
Magnum H.E. owner’s manual
R-134a H.E split system
warranty checklist
1. Verify that the evaporator unit (fan coil unit) box contains the following:
(1) Magnum evaporator unit
(1) Foam fan bracket
(2) Rubber grommets
(13/32")
Strip of cork tape (1”)
(2) ½” nylon plugs
(1) Flush mount template
(18) Antimicrobial pan tabs
(1) Drain line brush
6-1 3/4"PVC male adapter
KDT unit only
Flush mount template
KDT Plus display cable (50 feet)
KDT Plus wall mount bracket
assembly
KDT Plus flush mount bracket
assembly
KDT Plus display assembly
KDT Plus Hardware bag
(1) 11/16" OD Grommet
(2) ½” nylon hole plugs
(4) #6 x 1” PHP zinc Type A screws
(4) 8-10 x 7/8" Plastic Screw Anchor
Accessory kit bag:
Page 6
08/09/21
