CEL Power8 workshop, Руководство пользователя, Страница: 56 / 86

Table Saw - Assembly 10.3
How to mount the TABLE SAW GUARD:
Warning : Remove the battery handle from the
Circular Saw before assembling the TABLE SAW
GUARD.
If the TABLE SAW GUARD has not been installed,
then follow instructions below:
1. Turn the Circular saw head upside down as (1).
Retract the circular saw shield all the way and hold it
out of the way by using the lever on the side of the
product.
2. Align the protrusion on the metal support of TABLE
SAW GUARD and insert it to the hole on the sole
plate of the Circular saw. Then rotate the rear end of
TABLE SAW GUARD down over the riving blade as
fig.2.
3. Press the rear end of TABLE SAW GUARD down
until the latch hooks up with the sole plate. When it
fits flat with the sole plate of the circular saw. this
should now hold the Circular saw shield out of the
way.
4. The Circular saw is now ready to be installed into
the case.
Warning : Never operate the tool with any guard or
cover removed. Make sure all guards are operating
properly before each use.
NOTE. TABLE SAW GUARD is correctly mounted as
per fig 4 (mounted on when packed away)
NOTE. The Table Saw will NOT operate if the TABLE
SAW GUARD is not correctly mounted.
1
Hold it here
4
2
3
Table Saw - Assembly 10.3
5
6
5. Open the case and push the front of the sole plate
into the pocket on the underside of the case lid.
6. Pull back the green product lock slider and rotate
the rear of the circular saw into the case lid until the
sole plate is against the metal work surface, release
the product lock, check that it returns fully left. If it
doesn’t then the circular saw can’t be fully pushed in.
7. Remove the internal power coupling from its
storage pocket and slide it onto the top of the
circular saw until it will not go any further.
Warning : Never operate the tool with any guard or
cover removed. Make sure all guards are operating
properly before each use.
7