CEL Power8 workshop, Руководство пользователя, Страница: 55 / 86

Know Your Product
10.1
Table Saw - Specifications and Know Your Product
Voltage: 18V
No load speed:
Specifications
3,500 RPM
Blade bore:
3
/
8
” (10mm)
Cutting depth @ 0º: (20mm) ~ (38mm)
Cutting depth @ 45º:
(14mm) ~ (24mm)
Fence
Cut scale
Table saw shield
Work surface
Protractor
Cut scale
Fence lock
Please also refer to 2.1 - General Safety
Instructions and 6.2 - Additional Safety Rules -
Circular Saw before using the table saw.
Do not install the post and/or drill to the bench
for drill Press function while using the table
saw.
Keep guards in place and in working order.
Never operate the tool with any guard or cover
removed. Make sure all guards are operating
properly before each use.
Never start table saw when any rotating
components are in contact with workpiece.
Always use a fence or straight edge guide
when ripping.
Always use a push stick for ripping narrow
stock. A push stick is a device used to push a
work piece through the blade instead of using
your hands. Size and sharp can vary but the
push stick must always be narrower than the
workpiece to prevent the push stick from
contacting the saw blade.
Support large panels to minimize risk of the
blade pinching and kickback.
Provide adequate support to the rear and sides
of the saw table for wide or long workpiece.
Use only correct blades, do not use blades with
incorrect size holes. Never use blade washers or
bolts that are defective or incorrect. The
maximum blade capacity of your saw is 140mm.
Avoid cutting nails. Inspect for and remove all
nails from lumber of workpiece before cutting.
Never touch blade or any moving parts during
use.
Keep hands away from cutting area. Keep hands
away from blades. Do not reach underneath
work or around or over the blade while it is
rotating.
Do not attempt to remove cut material when
blade is moving.
Never attempt to free a stalled saw blade without
first turning the saw OFF.
Guard against kickback. Kickback occurs when
the blade stalls rapidly and workpiece is driven
back resulting in serious personal injury. Stay
out of blade path and turn switch off immediately
if blade binds or stalls.
Never leave the table saw running unattended.
Turn power OFF by pressing the RED Button.
Don't leave tool until it comes to a complete
stop.
Table Saw - Additional Safety Rules
10.2
3
/
4
”
1
/
2
” ~1
9
/
16
”
15
/
16
”
~
2
WS1-SB01 - 5 / " (136mm)
5
24 tooth TCT
kerf
5½” (140mm)
18 tooth TCT
0.06" (1.5mm) kerf
WS1-SB02 -
Saw Blade Options:
1
/
16
” (2mm)