5.3.1. NETWORK CONFIGURATION
To make a changes of default setting or new configuration of ADA-13040MG, select on left panel
Configuration -> Network
and then
on right
[IP Settings]
(Fig.15) and make the selection:
Obtain an IP address automatically using DHCP
or
Use the following IP
address
(in this case, enter IP Address of the converter, Subnet Mask, Default Gateway), press
[Apply]
for save. After the message
Changes have been saved successfully
, from left menu select
Administrator -> Reboot
on right press
[Reboot]
, will be
programmable reset of the converter and new configuration of network setting will be activated.
Fig 15. Network setting
5.3.2. SERIAL PORT CONFIGURATION
The configuration of serial port of the ADA-13040MG converter includes: port description, setting of port profile (operating mode) and
setting of serial transmission parameters (baud rate, data bits, parity, stop bits).
Select on left panel
Configuration -> Serial Ports
and then on right
[Port 1],
will open the configuration details page, includes:
- Port Profile Settings,
- Basic Serial Settings,
- Advanced Serial Settings,
5.3.2.1. PORT PROFILE (OPERATING MODE)
Select on right panel
Serial Port Configuration -> Port Profile Settings
and then press
Change Profile...
will open the page
Select
Port Profile
for selection of port profiles (fig. 16).
Configuration of profile used in typical solutions will be presented in next chapters.
The ADA-13040MG functions properly in profiles as follow:
- RealPort
- TCP Sockets
- UDP Sockets
- Serial Bridge
-Industrial Automation (Modbus Gateway)
Configuration of profile used in typical solutions will be presented in next chapters.
14
ADA-13040MG
