Ceetec IS-250, Руководство пользователя

Страница: 9 / 29

9/29
5.4 Forward drive
The forward drive propels the item through the machine. Adjust the backpressure roller by turning the
spindle using the handle. (See picture J)
Turning clockwise: the backpressure roller is moved upwards
Turning anti-clockwise: the backpressure roller is moved downwards
Bring the backpressure roller into contact with the item and tighten up approx. 1 turn, depending on how
hard the item is.
5.5 Test run and flow rate
1) Pull the item out.
Position the main switch on the control panel to "I" (power is connected). (See picture K)
2) Aktiver knappen ”Børster/Sanding” og hovederne begynder at rotere. Indstil den ønskede hastighed
på knap
(See picture K)
3) Activate the button ”Fremtræk/Pull” and adjust the forward drive to the desired speed with the
adjusting knob. (See picture K)
Feed the item into the inlet and check that the forward drive is running evenly.
If forward drive is not running evenly, adjust the backpressure roller. (See picture J)
The item can stop moving, if it hits the feeder guide, guide or brushes. In that case they should be re-
adjusted.
If the wood bends a lot, a problem can occur in the passage, because the wood will get stuck between
brush heads and guide. Therefore the wood has to be as plain as possible.
Test-drive with the same item 2-3 times. This is to make sure, that the machine is adjusted correctly.
Then make a test with a new item. If the result is satisfying, the machine is ready to use. Afterwards the
running is normal, however it is a good idea to check an item from time to time.