Ceetec IS-250, Руководство пользователя

Страница: 8 / 29

8/29
5. Adjusting the machine
The main switch on the control panel must be in position "O". (The machine is disconnected
from all power.)
NB: During the process, you have to take notice of scarp edges in the machine, which may cause
personal injury.
5.1 The lid on the machine is opened
Set the feeder guide, guide, backpressure roller and brushes to the outer position. Feed the item into the
machine.
5.2 Feeder guide and the guide in the middle of the machine
The feeder guides (pos 9015-20535, picture B/C) guides the item sideways and the roller in front of the
machine guides the item horizontally. Adjust the guides by loosening the wing screws and moving them
towards the item. There must be a 2-3 mm gap on both sides.
5.3 Sanding heads, brushes and screens/shields
The rotating sanding heads (horizontally and vertical) is adjusted so the wanted sanding effect is
achieved. The brush pressure is individually and depends of the treatment and the items profile. Ask if
necessary your sanding supplier for guidance.
The brushing (pos 9011-20567, picture A) is adjusted with the needed pressure, so dust will be removed
and collected in the brush shield (pos 9015-20538, picture D)
. Also here the brushing pressure is
individually. The brushing is produced in durable nylon.
The brushes can be mounted and demounted with a single grip. (See picture E)
The sanding heads can be mounted and demounted by loosen the 3 stopscrews and pull the lock
washer of. (See picture F and G)
The adjustment of the horizontally sanding heads and brushes is done by leading the pole into the
square pipe on the brush module. (See picture H)
The adjustment of the vertical sanding heads is done by leading the square pipe, plus the pole down
over the square pipe on the sanding head module. (See picture I)