Ceetec IS-250, Руководство пользователя

Страница: 10 / 29

10/29
5.6 Opening the lid
NOTE THAT THE MACHINE, FOR SAFETY REASONS STOPS, WHEN YOU OPEN THE LID.
Attention: The lid on the forward drive and brushes is hinged and can be opened.
The lid is connected to a switch, which stops the forward drive, if the lid is open.
To start the forward drive the lid must be closed. If the lid is opened while the machine is activated the
forward drive stops immediately. To restart the machine the lid must be closed and a new start
command must be given on the start button.
5.7 Reversing of circulation direction on the sanding heads
To obtain the wanted sanding result, the circulation direction on the 2
nd
horizontally sanding can be
reversed (the sanding head is attached to the arrangement with pos. 9015-20522, spare part picture A)
As standard, the machine is configured to both horizontal sanding heads running
against the item's
travelling direction.
The circulation direction can only be reversed by the before mentioned horizontal sanding head. Thus
can the circulation direction not be changed on any on the vertical sanding heads.
Procedure for changing the circulation direction (when configured to running against the wood):
Before the replacement can begin, the main switch must be turned to position ”0” and the plug removed.
1. Demount the sideplate, so access to the machines transmissions elements is achieved (spare
part picture C)
2. The tightenwheel is loosen from pos. A (see picture N). The toothed belt (pos. 9015-20525) is
demounted and placed in the opposite direction around the pulley (see picture Q). The tighten
roll is then mounted again in pos. B (see picture P) and the belt is tighten.
Picture O
Standard belt mounting. Belt tightener in pos A.
This mounting gives the following result:
Vertical sanding heads: running against the item
1. horizontal sanding head: running against the item
2. horizontal sanding head: running against the item
Brushing device: running against the item
Picture Q
Reversed belt mounting. Belt tightener in pos B.
This mounting gives the following results:
Vertical sanding heads: running against the item
1. horizontal sanding head: running against the item
2. horizontal sanding head: running
with the item
Brushing device: running against the item
Check and adjust if necessary the belt after approx. 20 hours of operation.