Cedar AZX+, Руководство пользователя

Страница: 22 / 36

Q
If the red, upward-pointing arrow is lit, you can turn the
ADJUST
knob
clockwise to move closer to the autotracker value.
Q
If the downward-pointing arrow is lit, you can turn the
ADJUST
knob
anticlockwise to move closer to the autotracker value.
Note: If the central green
LED
is lit alone then the displayed
TIME SHIFT
is within a quarter
of a sample of the detected value. If an arrow and the central LED are lit together
then the displayed value is within one sample of the detected value. If an arrow is
lit alone then the displayed and detected values differ by more than one sample.
Reset
To reset the
AZX
+, press the
ADJUST
knob, rotate it until ‘
ZE
ro’ is displayed, and
then release it.
Monitor modes
Once you have determined the correct timing correction, the
AZX
+ will process
the signal according to the following monitor mode controls:
Monitor mode:
PRE/POST
Q
POST
The time shift shown in the display is applied to the signal.
Q
PRE
The value shown in the display is ignored, and the signal is unaffected by
the
TIME SHIFTER
.
This control allows you to make quick, glitch-free
A/B
comparisons of the
signal before and after azimuth correction.
Monitor mode:
STEREO
/
MONO
;
SUM
/
DIFFERENCE
Q
STEREO
The left and right signals from the
TIME SHIFTER
are passed to the left and
right outputs.
Q
MONO
The left and right signals from the
TIME SHIFTER
are either summed, or the
right channel is subtracted from the left channel, according to the position
of the sum/difference control. The resulting monophonic signal is passed to
the left and right outputs.
Note: If the original audio is a true mono signal with the left and right channels in
perfect alignment, the result of selecting
MONO
/
DIFFERENCE
will be perfect
cancellation (silence).
Note: Since
SUM
and
DIFFERENCE
are not applicable to
STEREO
mode, the control is
disabled when
STEREO
is selected.
PAGE 16