ENGLISH
33
Note:
•
Do not use the scrubbing function while the robot is unattended.
•
Remove the mop bracket when the robot is charging or not in use.
•
If there are carpets in the house, set Restricted Areas to avoid the robot from passing
over them.
•
Add some drops of cleaning agent (not corrosive) if considered necessary.
Warning: The excess of cleaning agents might block water outlets.
5. To remove the mop bracket, press the release button and pull from it outwards.
Warning: In order to achieve perfect scrubbing, it is suggested to moisten the mop before
using it.
FIRST CLEANING
Once the robot and the charging base are completely installed, follow these steps before
scheduling the first cleaning cycle.
First of all, the robot must be fully charged. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the first cleaning cycle and save the first
map. To do so, activate Auto cleaning mode and Eco power level. It is very important to follow
these indications for the robot to recognize each and every corner in the house and to create
a complete map.
If the house where the robot is going to be used is too big and the robot runs out of battery, do
not worry. The robot returns to the charging base, saves the full map and those that have not
been completed, and once it is charged again, it resumes the cleaning cycle from the point it has
stopped until it maps 100 % of the surface. The robot keeps on mapping constantly, therefore
it adapts independently to each house’s features and improves previous maps continuously.
5. OPERATION
•
Once the robot’s light indicator changes from blinking orange to steady blue, the battery
is fully charged and the robot is ready to operate.
•
The robot cannot operate with low battery.
Recommendation:
Remove all cables and obstacles from the floor before operating the robot
in order to avoid accidents and damage.
