![Cebora MONO STAR Скачать руководство пользователя страница 10](http://html1.mh-extra.com/html/cebora/mono-star/mono-star_instruction-manual_2577540010.webp)
10
F
G
E
5 INSTALLATION AND START-UP FOR MIG WELDING
WITH GAS
Position the welding machine so as to allow the free circulation
of air inside and, as much as possible, prevent metal or other
dusts from penetrating.
• The machine must be installed by professional personnel.
• All the connections must be performed in compliance
with applicable standards (IEC/CEI EN 60974-9) and with
accident-prevention laws.
• Make sure the power supply voltage corresponds to the
welding machine rating.
• The protection fuses must be sized according to the details
shown on the technical data plate.
Make sure the earth lead D, inside the reel
compartment, is connected to the negative pole
coming out of the dividing wall.
Alongside the 2 terminals, the polarity is printed in
relief. The positive pole + is that at the top, nearest
to the wire feed motor. The negative pole – is the one
lower down, nearest to the earth lead exit.
Connect the earth lead clamp
D
to the piece to be welded.
Open the side door. Fit the wire reel according to the
instructions provided below.
REEL FITTING SEQUENCE
REEL FITTING SEQUENCE
NOTE. During the
fi
tting sequence, the welding machine
must be switched off to prevent the moving motor roller
representing a risk for the operator.
• Fit the reel on the support inside the compartment as
shown in
fi
g. 1.
• The reel must be
fi
tted on the support so the wire
unwinds in an anticlockwise direction. It is important
for the wire to be stopped on the reel on the visible
side, see
fi
g. 2. Block the reel on the support, as shown
in the illustration.
• Make sure the drive roller is correctly positioned
according to the diameter and type of wire used. To
remove the roller, align the
fl
at part of the roller-bearing
pin at the bottom, so the key can be
fi
tted inside the
retention screw. Loosen the screw, remove the roller,
fi
t
the roller back on so the race corresponds to the wire
used, see
fi
gures 3 and 4.
• Cut the wire with a well-sharpened tool, keeping it
between your
fi
ngers so that it cannot unwind, insert it
inside the plastic pipe exiting from the gear motor and,
with the aid of a
fi
nger, also insert it inside the steel tube
until it comes out of the brass adapter, see
fi
gures 5-6-
7-8.
• Close the drive arm, being careful of the wire, which
must be aligned with the roller race, see
fi
g. 9.
• Fit the welding torch.
After
fi
tting the reel and torch, switch on the machine, select
the suitable synergic curve, following the instructions given
in the service functions (
PROCESS PARAMS
) paragraph.
Remove the gas nozzle and unscrew the current nozzle
of the torch. Press the torch button until the wire comes
out.
BE CAREFUL to keep your face away from the end
Содержание MONO STAR
