Cebora 465.01, Инструкция по эксплуатации

Страница: 43 / 76

43/48 3301069/A
EN
7.4 SCF – Start Current Flow.
Plasma gas flow rate during start current (first level current).
If the first level current is zero, the
SCF
parameter is ineffective.
Range = 0.2 ÷ 10.0 l/min.
Default = 1.0 l/min.
From the TIG touch panel:
MENU -> Plasma Welding Parameters -> Initial Flow Rate
7.5 SUP – Slope Up gas Plasma.
Slope plasma gas between SCF and PLF ; if ON exactly follows the slope-up time of the power source current; if OFF,
the variation between SCF and PLF is stepwise.
Range = OFF – ON.
Default = ON.
From the TIG touch panel:
MENU -> Plasma Welding Parameters -> Initial Slope
7.6 FSP – Final Slope gas Plasma.
Plasma gas slope between PLF and CrF ; if ON exactly follows the slope-down time of the power source current; if OFF,
the variation between PLF and CrF is stepwise.
Range = OFF – ON.
Default = ON.
From the TIG touch panel:
MENU -> Plasma Welding Parameters -> Final Slope
7.7 CrF – Crater Flow.
Plasma gas flow rate during crater current (third level current).
Range = 0.2 ÷ 10.0 l/min.
Default = 1.0 l/min.
From the TIG touch panel:
MENU -> Plasma Welding Parameters -> Crater Gas Flow Rate
7.8 POt – POst flow time.
Plasma gas postflow time, i.e. postflow time after pilot arc deactivation.
Range = 0.0 ÷ 25.0 s.
Default = 10.0 s.
From the TIG touch panel:
MENU -> Plasma Welding Parameters -> Postgas Duration �
7.9 GPt – Gas Plasma type.
Choice of correction factor applied by the flow regulator based on plasma gas type.
Plasma gas
type Ar% He% H2% correction factor min.
Ar 100 - - 1�17 0�2
He 0 100 - 8�59 0�2
Helistar He 70
30 70 - 4�43 0�2
Helistar He 30
70 30 - 1�93 0�2
Range = 0.2 ÷ 9.99.
Default = 1.17
From the TIG touch panel:
MENU -> Plasma Welding Parameters -> Plasma Gas