![Cebora 208-10 Скачать руководство пользователя страница 35](http://html1.mh-extra.com/html/cebora/208-10/208-10_instruction-manual_2577434035.webp)
CEBORA S.p.A.
35
3.300.189-B
04/03/2016
GB
5.3.4
Burn-Back Time Correction.
Set the wire length exiting the torch nozzle after welding, expressed as a time interval (milliseconds).
The
Burn-Back Time Correction
adjustment is enabled or disabled by means the
Burn-Back Time
Correction Disable
function, available on RAI211 and RDI210 Robot Interfaces.
The corresponding bit is controlable with dip switch S1-4 on RAI211 Robot Interface or with the signal
“I100” of the Data-In Process Image on RDI210 Robot Interface (see Robot Interface Instruction
Manual):
-
with
“Burn-Back Time Correction Disable”
not active (S1-4 = OFF, or I100 = low) the
“Burn-
Back Time Correction”
adjustment is enabled in
Standard program,
Pulsed arc program
and
Manual
modes, and follows the value set at Robot Interface analog input 4. The adjustment is carried
out via Robot Terminal;
-
with “
Burn-Back Time Correction Disable
” active (S1-4 = ON, or I100 = high) the “
Burn-back
Time Correction
” is not active.
Independently from the
Burn-Back Time Correction Disable
function state, in
Parameter Selection
Internal mode
, is always possible to adjust the
Burn-Back Time Correction
from Control Panel (par.
7.9).
Correction regulation range: -125 ÷ +125 ms.
The
Burn-Back Time
effective value after the correction is always comprised between 4 ms. and 250 ms.
When the correction set up is equal to 0 the
Burn-Back Time
parameter is set to its default value,
indicated with
Au
(automatic).
Содержание 208-10
Страница 67: ...CEBORA S p A 67 3 300 189 B 04 03 2016...