18
cdvigroup.com
EN
ATRIUM A22POE
2-Door Controller
INSTALLATION MANUAL
EN
ATRIUM A22POE
2-Door Controller
INSTALLATION MANUAL
INPUTS
The A22POE can monitor the state of up to 6 devices (12 using zone doubling) such as magnetic contacts,
motion detectors, temperature sensors, or other devices. The following are examples of the type of inputs that
can be monitored:
Magnetic Door Contact:
Permits supervision of door “status” (opened, closed, opened too long, forced open). Inputs “Door
Contact 1” and “Door Contact 2” are assigned by default as the door contact for Door 1 and Door 2
respectively. When using the default system settings, you can easily swap terminals to troubleshoot
the installation.
Request to Exit (REX):
The device used can be a push button, vertical-view motion detector or floor mat sensor. The door can
then be programmed to unlock on a REX detection. When a magnetic door contact is installed, the
system can differentiate between a door forced open and an authorized exit. Inputs “REX 1” and “REX
2” are assigned by default for Door 1 and Door 2 REX inputs respectively.
Door 1
Factory Default Input Settings
(same settings for door 2)
N.C. Door Contact
(Remove the jumper
before installing
the door contact)
N.C. REX1
+12Vdc
N.C.
Com.
-
INPUTS/
OUTPUTS
RS485
LOCAL
BUS
BATTERY
(12V DC)
INPUT
POWER
SUPPLY
ETHERNET
LOCAL
BUS
STATUS
LOCK 1
SETTING
LOCK 2
SETTING
READERS
INPUTS
LOCKS
A22
2-Door Web-Based IP Module
DOOR 1
DOOR 1
DOOR 2
DOOR 2
DOOR 1
DOOR 2
D
ATA
1
Red LED 1
Green LED 1
Buzzer 1
D
ATA
0
+12V DC
D
ATA
1
Red LED 2
Green LED 2
Buzzer 2
D
ATA
0
+12V DC
Com. Relay 1
N.O. Relay 1
N.C. Relay 1
Lock output 1
Com. Relay 2
N.O. Relay 2
N.C. Relay 2
Lock output 2
Door Contact 1
REX 1
+12V DC
Door Contact 2
REX 2
+12V DC
Tamper Switch
+24V DC
-
+12V DC
-
+12V DC
A+
B-
Input 1
Input 2
Output 1
+12 V DC
Output 2
ETHERNET
24V DC INPUT
BATTERY
MODULE TYPE
SYSTEM STATUS
Two Extra Inputs
(4 using zone
doubling)
See “Recommended Wiring” section for more information on wiring type, size, and maximum length.
