Specifications
Temperature Alert:
-40 to 482°F/-40 to 250°C
°F/°C selectable
Timer:
10 timers;
Counts down 24 hours
by minutes & seconds
Power:
2 DC 1.5V size AAA
Precautions
• Always read the user manual thoroughly before
operating.
• Clean the probe and sensor cable with warm soapy
water and dry thoroughly after use.
• Avoid cleaning the unit with an abrasive or corrosive
compound, which may scratch the plastic parts and
corrode the electronic circuits.
• Avoid subjecting the thermometer to excessive force,
shock, dust, temperature, direct sunlight or humidity.
This may result in thermometer malfunction, shorter
electronic life span, battery damage and/or distort
parts.
• Avoid tampering with the thermometer’s internal
components, which may cause battery damage and
distort parts.
• Avoid immersing case into water or expose to heavy
rain. The cases are not waterproof.
• Do not use the probe in microwave oven.
•
Do not touch with bare hands
— always wear heat
resistant gloves to touch the probe or sensor cable
during or after cooking.
• Keep the batteries, probe and sensor cable away from
children.
• Avoid subjecting the probe or sensor cable to an open
flame on the BBQ.
• Avoid subjecting the probe to temperatures outside
the range of -40 to 482°F/-40 to 250°C. The high-heat
sensor cable is safe up to 716°F/380°C.
Note:
Clean the thermometer stem before each use.
Note for Induction Cooktops:
Sometimes, the induction
cooktop magnetic field may interfere with digital thermometers.
If there is interference, briefly turn off the induction cooktop to
get a digital thermometer reading or use a dial thermometer.
Important: DO NOT LEAVE THERMOMETER IN HOT OVEN
OR MICROWAVE. HAND WASH AND DRY
Tip:
Meat should be allowed to “rest” for 10 to 15 minutes
after it is removed from oven. This allows time for the meat’s
internal temperature to stabilize and the juices to redistribute.
This will result in a roast that is both juicier and easier to carve.
CAUTION: Avoid keeping the thermometer too close to
objects that continuously generate high heat for long
periods (i.e., hot plate). This can cause the thermometer
to overheat.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including
interference that may cause undesired operation.
© 06-2015 Component Design Northwest, Inc.
Made in China
CD9999279en - 6/15 L-DESIGN 614.525.1472
The information in this document has been reviewed and is
believed to be accurate. However, neither the manufacturer nor
its affiliates assume any responsibility for inaccuracies, errors
or omissions that may be contained herein. In no event will
the manufacturer or its affiliates be liable for direct, indirect,
special, incidental or consequential damages arisen by using
this product or resulting from any defect/omission in this
document, even if advised of the possibility of such damages.
The manufacturer and its affiliates reserve the right to
make improvements or changes to this document and the
products and services described at any time, without notice
or obligation.
5-Year Limited Warranty:
Any instrument that
proves to be defective in material or workmanship
within five years of original purchase will be repaired
or replaced without charge upon receipt of the
unit prepaid at: CDN, PO Box 10947, Portland, OR
97296-0947. This warranty does not cover damage
in shipment or failure caused by tampering, obvious
carelessness or abuse.
CE Note:
This device could be sensitive to electrostatic
discharge. If electrostatic discharge or malfunctioning occurs,
please re-install the battery to reset this unit.
For more detailed
information on our
products, please visit
cdn-timeandtemp.com.
