13
25mm
35mm
500 x 10mm
500 x 10mm
25mm
Fig.3
Fitting the Hob
Unpacking the hob:
Take care not to lose, drop or
mishandle any parts.
Fitting position of the hob:
This appliance must be installed a
minimum of 55mm away from any
adjacent vertical surfaces, e.g. a
tall cupboard end panel. These
dimensions are shown in Fig.7 on
page 15. If installing the hob in a
cupboard unit, or above a drawer,
then a partition panel must be used.
Ventilation requirements:
This appliance must be installed
to allow air to flow freely to the air
intake and from the air outlet. An
air gap of 25mm is recommended
immediately below the hob.
Failure to allow sufficient ventilation
could cause problems with
operation or damage to the hob
and constitutes incorrect installation,
which is not covered by the product’s
warranty (Figs. 3 and 4).
Fig.4
Installation above a cupboard unit
Installation above an oven unit