ENGLISH
12
6.
Switch on
–
Switch off
➢
The lamp is not equipped with an
independent switch on-switch off
system.
➢
The lamp will switch on when
plugged-in and switch off when
the power is off.
7.
Problem solving
In case the lamp doesn’t turn on
:
➢
Check that the lamp is properly
wired to the supply voltage.
➢
Check that polarity wiring has
been carried out correctly.
Please conta
ct CCEA’S Technical su
pport
service in case the lamp is defective
CCEA Technical Support Service
Phone: +39 0444 572083
8.
Replacing the LED light
source
The outstanding lifetime of the LED
light source, over 60.000 hours,
makes it unnecessary to replace the
PCB LED if the lamp is properly
installed and used following the
instructions in this manual. Please
contact CCEA
’s
Technical Support
service - or your Reseller
–
in case the
replacement of the PCB LED is
needed for any defects not covered
by the warranty.
9.
Product maintenance and
cleaning
Switch off the power supply before
any installation, maintenance or
reparation procedures.
This product is maintenance-free.
➢
Lamp cleaning to be carried out
only after it has been switched
off and surfaces have cooled.
➢
Carefully rinse the lamp surface
with a mild cleanser and then
wipe off using a soft cloth in
order to avoid scoring it.
All material damages caused by
liquid leakage may damage the
lamp.
➢
In case the lamp is working in
environments where lubricants or
coolers are present, all cleaning
operations should be carried out
at the end of the working cycle.
WARNING
NOTICE
Maintenance
