VRC2100 Vending Reader
6
Installation Guide
9.
Confirm that all cables are secure and safely routed. Apply power to
the vending machine and configure the VRC2100 network port as
described in section 3.3 (
Network Configuration
).
10.
Configure the VRC2100 controller as described in section 3.6
(
Controller Configuration
). Remove power after this step is
completed.
11.
Attach the VRC2100 to the mounting panel with the four security
screws supplied using a ⅛
”
Security Hex Driver (part number
3VNDGR5251261000 or 3VNDGR5251260000). This may require
temporarily removing the VRC2100 mounting panel from the
vending machine. Fully tighten the four KEPS nuts to secure the
mounting panel to the vending machine.
12.
Close and lock the vending machine door, and apply power to the
vending machine.
13.
Configure the Host as described in the
CS Gold
Server Guide
.
Alternatively, the configuration can be done in a more convenient
location before installing the VRC2100 to the vending machine using
the External Power Supply (part number VND6740086).
3.3 Network Configuration
The XPORT is configured using the
Device Installer
program, available
from Lantronix
®
at the following site:
http://www.lantronix.com/support/downloads/?p=DEVICEINSTALLER
After installing the software package, access the software and wait a few
seconds for it to find all Lantronix hardware on the local net. There could
be several XPORT-03 devices found, so to make sure you are selecting the
proper one, compare the MAC address printed on a sticker on the
VRC2100 with the MAC IDs found by the program. This will be a
12-digit number with dashes, such as 00-20-4A-80-66-59.