CBC (America) www.computarganz.com
5
USER MANUAL
All cameras are equipped with LAN connector and can deliver image data at a
maximum data rate of up to 55 Mbps. Images are sent over the network in a
compressed Motion JPEG format using TFTP protocol.
All cameras feature:
•
Automatic exposure (AE) and Gain (AGC) control
•
Automatic backlight compensation
•
Automatic multi-matrix white balance
•
50/60Hz selectable flicker control
•
Electronic Zoom, Pan and Tilt (PTZ)
•
Programmable brightness, saturation, gamma, sharpness, windowing and
decimation
•
Simultaneous delivery of full-field view and zoomed images at video frame
rate
•
Electronic image rotation by 180 degrees
•
On board motion detection (except MP8D / MP8P: subject to change)
•
Optional auto iris
Connectors
All MP cameras have the following connectors located on the rear panel of the
camera housing:
•
LAN connector, accepting a network UTP or STP cable carrying 100 Base-
T. The LAN connector also accepts Power-over-Ethernet (PoE)
•
Power terminals, accepting 12V-48V DC switching power supply or better
•
Optionally, a DC auto-iris connector. MP3-DN does not support auto-iris
and does not have this connector
Power
Power for all MP cameras can be supplied as follows:
•
Via DC jack, 12V-48V. For power ratings see below. The center contact in
the power connector is positive. A Switching type or better (inexpensive
transformer types induce too much signal noise).
•
Via LAN connector, 48V DC over spare wires or over data pairs. The
cameras are compliant with IEEE 802.saf. The polarity is arbitrary. (For a
list of recommended PoE switches, see “
Network Switch or Router
”
on
page 4
)
Power consumption will vary depending on the mode of operation. The maximum
power consumption takes place when the camera is polled at full frame rate and
runs at full resolution. The maximum power consumption is 4 Watts for MP1,
