6
7 INSTALLATION
7.1 Side-mounted cameras
Note:
If NOT using the side-mounted camera feature of the
Height Strip, proceed to the next applicable section.
1. Refer to
Figure 5
when side-mounting a camera.
2. Two positions are available for side-mounted cameras,
one directly below and one directly above the center
mounting location (5.5-foot mark). Select which mounting
location you prefer.
3. Determine which direction the camera should face once
installed. Remember to use the keyhole as a guide. The
round part of the keyhole faces the ground.
4. Change the camera bracket’s pivot point. Remove the
M3 nut, flat washer, and nylon washer from the camera
bracket using a 5.5mm (7/32”) nut driver or socket.
Note:
the nylon washer is located between the camera
bracket and the “L” bracket. Be careful not to lose it.
5. Place the nylon washer over the pem stud of the camera
bracket (a.k.a. camera bracket axis), then insert the pem
stud into the side of the “L” bracket OPPOSITE the
direction of the camera. Replace the flat washer and M3
nut and tighten (see “Note” in
Figure 5
).
6. Before drilling, remove the camera bracket and “L” bracket
from the base. Hold the cover next to the base. Locate
the two small indentations (countersinks) on each side
of the cover. Mark the countersink that corresponds to
your mounting location.
7. Fit the cover back over the base and tighten down the
four (4) M3 screws to secure.
8. Locate the marked countersink in the cover.
9. Drill out an appropriate sized hole in the Height Strip
cover using the following guidelines:
Color
Camera
a. If using a step drill bit (recommended), drill the
hole to 3/8-inch diameter.
b. If using standard drill bits, first use a 1/8-inch bit,
then 1/4-inch bit, then a 3/8-inch bit. This will
minimize chatter and help ensure a round hole is
drilled.
10. Remove the four M3 screws to remove the cover.
Remove any burrs from the inside of the cover.
11. Install the camera in the side-mounting location using a
flat washer and M3 nut. Proceed to the next applicable
section to complete the installation.
“L” bracket
Original Location
of Axis
Note:
This camera bracket
has been adjusted
to look 90º RIGHT.
Note that the camera bracket axis
was moved to the LEFT Side of the “L” bracket.
Flat Washer
M3 Nut
Camera Bracket
Axis (pem stud)
Nylon washer
(in between)
Left
Right
Up
Do
wn
M3 Nut
Flat Washer
Figure 5 Side Mounted Cameras
