Cayin SMP-WEB4, Руководство пользователя

Страница: 28 / 159

USER MANUAL
20
2-4-2 Step2: Display Settings
Here you can configure the settings relevant to the display
device. According to the actual screen connected to the SMP
player, please configure its screen resolution and refresh rate.
On some SMP models, you can select the video signal output. If
you would like to cut off the VGA signal in specific time to let the
screen switch to the standby mode (applicable to most today's
screens for power saving), you can configure the applied time
and days.
SMP-WEB4
1. Choose an output method from the drop-down menu and
display configurations such as display orientation and
resolution. Those information will be shown below the drop-
down menu according to your selection. Please configure the
settings accordingly.
2. Tick " Hide Cursor " checkbox if you don’t want to see the
cursor on the screen.
3. If you want to turn off the display (SMP will cut down the VGA
or DVI output automatically), you can set a specific time of
a day or day of week to cut off the VGA/DVI signal at the
bottom of this page.
4. Click [ Next ] to save all the settings.
SMP-WEB4 supports to
display single content on
two screens connected by
the VGA and the DVI-D
connectors. We strongly
recommend you to use two
pre-tested and identical
screens to properly work this
function.
If you choose DVI or VGA
output (not Auto), those
resolutions with * sign after
the number are supported
by display’s EDID (or DDC)
i n f o r m a t i o n . C h o o s i n g
those resolutions without *
sign is not suggested and
the system may not work
properly. If you cannot see
any * after the resolution
number, please check your
display maker or your VGA/
DVI cable for EDID signal
support.
Most screens will enter the
sleep mode when the VGA
or DVI signal is cut down by
the SMP player. However,
some screens might respond
un e x p e c t e dl y, s u c h a s
showing a blue screen. The
outcome depends on the
firmware of each screen, not
SMP player.