Cattron Remtron Patriot 25R15A, Руководство пользователя

Страница: 22 / 28

Remtron
®
Patriot
User Manual
22
9M02-9028-A001-EN
Rev 12
Figure 7: Handheld Transmitters
– Access to Batteries and Programming Plug
7.5 Receiver Troubleshooting
7.5.1 General
Refer to Figure 5 in Section 6.6 for the location of the diagnostic LEDs. The Patriot receivers have diagnostic
LEDs that aid in identifying a problem if one occurs. The following table describes the diagnostic LEDs.
LED Meaning
PWR Receiver operating voltage is present when this LED is lit
SIGNAL
A signal is being received that matches the decoder’s address when this LED flashes
(MLC should be active)
OUTPUT One or more command outputs are energized when this LED is lit, not including MLC relay
7.5.2 Receiver Testing
Follow these steps when troubleshooting the Patriot receivers.
1. Check the POWER LED. If this LED is not lit:
•
Check that the power source to the receiver is present
•
If 115 VAC is present between the WHT and BLK wires on the interface cable, replace fuse F3 if
present on the receiver circuit board (See
Fuse Replacement )
2. Switch the transmitter to ON. The SIGNAL LED should start to flash. If it does not:
•
Test the transmitter
•
Verify that the ID Code is the same for the transmitter and the receiver
3. If only some functions are operating: