Cattron Remtron Patriot 25R15A, Руководство пользователя

Страница: 20 / 28

Remtron
®
Patriot
User Manual
20
9M02-9028-A001-EN
Rev 12
7.4.1 Normal Operation
When the transmitter is operating normally, the LED indicator emits short flashes at a low rate when no
commands are activated, and at a higher rate when a command is activated.
Some transmitters use a red LED only. Others use a multicolored LED that flashes green when no problems are
present and changes to red under low battery conditions or when other problems are encountered.
Table 2: Transmitter Troubleshooting Chart
Problem Possible Cause
LED is off Transmitter is off
– switch transmitter ON
Batteries are dead
– replace batteries
Transmitter failure
– contact Cattron at
www.cattron.com/contact for
service
LED flashes at low rate Transmitter is operating in a normal mode
LED flashes at high rate Command switch is pressed
LED flashes Red/Green (‘A’
series only)
Batteries getting low
– change batteries at the next convenient
opportunity
LED flashes on-off at a slow rate
(½ second on and ½ second off) Batteries getting low
– change batteries at the next convenient
opportunity
LED remains on continuously
(LED might flicker slightly) A switch was activated at the time the transmitter was switched on or a
general failure occurred that requires factory service. Ensure no other
switches are pressed while attempting to switch the transmitter on
LED will not light when ON/OFF
button is pushed Replace batteries. If this does not correct the problem, the transmitter
must be repaired
7.4.2 Replacing the Transmitter Batteries
WARNING
The transmitter’s electronic components are exposed when the back of the case is removed. Take
care to prevent dirt or other contaminants from entering the case. Do not allow the circuit to be
scraped or damaged in any way.
Handheld Transmitters
Refer to Figure 7 in Section 7.4.4 for your particular transmitter.
1. For Standard transmitters, fully release the two captive screws and remove the battery door.
2. Remove and replace the AA Alkaline batteries. Be sure to observe the correct polarity .
3.
For Standard transmitters, fully replace the battery door and secure using the two captive screws. ‘A’
Series Battery door screws should be tightened until snug, plus half a turn.
!