18
OPERATING YOUR STAND MIXER KM 8020
ATTENTION:
If you are going to process solid
mixtures such as bread doughs, do
not run the stand mixer for more
than 10 minutes. Then, turn the stand
mixer off and let it cool down for
about 10 minutes.
ADJUSTING THE WHISK
You can adjust the whisk so that it is placed
lower or higher in the container so you can
easily whisk the ingredients.
WARNING!
Always adjust
the whisk when
removing it from
the shaft. The
whisk must not be
mounted on the
shaft.
The whisk can be unscrewed or screwed at
the top of the whisk.
If you need the whisk to be placed higher in
the container, turn the screw clockwise.
If you need the whisk to be placed lower in
the container,turn it counter-clockwise.
Check the position of the whisk by attaching
it to the shaft and adjusting it if necessary.
NOTE
The kneading hook and fl at beater
are factory set to the optimum height
in the container. They cannot be
adjusted.
ATTENTION:
Be careful not to unscrew or screw
the screw too much - it could fall out
of the whisk. In addition, if you screw
the screw too much, it may interfere
with the whisk on the shaft when it is
properly seated.
SAFETY FEATURES
If you plug the power cord into a power
outlet while the speed control is set to
a certain speed, the food processor will not
start and the light will fl ash. Disconnect the
power cord from the power socket and set
the control knob to "0".
If you lift the arm while the food processor is
running, the food processor will turn off and
the light will go out. If the arm is lowered, the
light will fl ash. Turn the speed dial to “0” and
then select the speed again.
If the engine overheats, the food processor
will automatically shut down and the light
will fl ash. Turn the control to “0”, disconnect
the power plug from the power outlet, and
allow it to cool.
