Catler JS 8011, Инструкция по эксплуатации

Страница: 15 / 25

13
OPERATING YOUR JUICER ES 8011
1. Put the motor base on a clean, dry and
fl at surface far enough from the mains
socket.
2. Insert the chamber on the motor base so
that jags on the motor base engage with
the notches at the chamber bottom.
3. Insert the strainer in the chamber. Each
strainer has indentation at the bottom
which must fi t in the chamber bottom
indentation to make sure the strainer is
properly fi xed in the chamber.
Please select appropriate strainer
depending on the type of the selected
fruit and vegetables:
- A fi ne strainer is suitable for
processing hard fruit and raw
vegetables.
- A coarse strainer is suitable for
processing soft fruit or vegetables.
- An ultra-fi ne strainer is suitable for
processing fruit or vegetables to
prepare ice creams or sorbets.
NOTE
If you are about to juice both hard and
soft fruit or vegetables (such as apples
and bananas), put either the fi ne
strainer (juice making without pulp) or
the coarse strainer (juice making with
pulp a la smoothie) in the chamber.
4. Insert the press screw onto the shaft.
Rotate the screw as needed to make sure
that it’s inserted correctly.
5. Now insert the feed tube so that the
arrow on the chamber is aligned with the
open lock mark on the tube.
6. Rotate the tube clockwise until the arrow
on the tube is aligned with the open lock
mark. Correct tube locking is indicated by
clicking.
NOTE
Do not use force when inserting the
feed tube. If the feed tube cannot be
inserted, check if the press screw is
installed correctly.
WARNING!
The juicer
won’t start
unless correctly
assembled.
7. Put the pulp container under the pulp
outlet and put the juice container under
the juice spout.
8. The juicer is now ready for use.
OPERATING YOUR JUICER
Before plugging the power cord in the mains
socket and turning the juicer on, please make
sure that juicer is correctly assembled.
The juicer is equipped with two safety
devices that prevent it from being started
after plugging the power cord:
-
the feed tube is not installed correctly;
- the feed opening’s protective lid is open.
1. Insert the mains cord plug into a power
socket.
2. The control panel will light and the juicer
is ready for use.