Castelle FAXPRESS PREMIER, Руководство администратора

Страница: 578 / 639

Admin Guide > Analog Hardware Upgrade
562
Required Tools
The FaxPress Premier Analog fax board upgrade requires a Phillips head screwdriver.
Upgrade Kit Contents
Make sure the FaxPress Premier Upgrade Kit contains the following components:
„
One, two or three Intel Dialogic Intelligent Fax Board(s)
„
One Castelle Upgrade Distribution CD
Note: Make sure the 8-digit serial number displayed on the left side of the label
on the CD (for example, S/N 84100200) matches the serial number on the
label on the bottom of your FaxPress Premier server (for example, SERIAL NO.
84100200). If the serial number doesn’t match, contact Castelle tech support
immediately. If you are upgrading more than one FaxPress Premier, use the
correct upgrade CD for each server, or the software upgrade will fail.
Adding Fax Boards
The procedure used for adding an inital upgrade board to the FaxPress Premier Analog is
different from the one used for installing additional upgrade boards. See Adding an Initial
Upgrade Analog Fax Board on page 562 below to add a board to a unit that has not yet
been upgraded. For units that have previously been upgraded, please see Upgrading with
an Additional Analog Board on page 566. Each new fax board added will provide support
for 4 additional fax lines.
Adding an Initial Upgrade Analog Fax Board
Follow the steps in this section only if you have not already added an upgrade board to
this unit before. To add an initial upgrade board, follow these steps:
1. Discharge static electricity from yourself by touching a grounded surface and at-
tach a grounded static-dissipative wrist strap. Make sure the working sur-face is
static-dissipative and grounded.
2. Shut down the FaxPress Premier from the console by accessing the System Infor-
mation folder in the System & Diagnostics folder, and then right-clicking in the
blank section of the list to the right side of the Faxmain window and choosing the
System Shutdown command. When the system has shut down, disconnect the
power cord from the unit.
3. Remove the 5 cover screws holding the cover of the FaxPress Premier to the back
panel, the 3 screws holding the bottom of the cover to each side of the chassis,
and the 2 screws holding the front edge of the cover under the lip at the top of the
front panel. The screw directly above the thumbscrew for the fan unit cover does
not need to be removed, but may need to be loos-
ened.