4
Juno & Vulcan
Issue 01 06/13
3.1.5 Fuels
Only use recommended fuels which are seasoned (or kiln dried) wood logs or
smokeless briquetted fuels. The appliance can be damaged by burning petroleum coke,
liquid fuels or general rubbish and this will invalidate your warranty and risk your
personal safety.
The appliance must not be used as a rubbish incinerator
.
3.1.6 Maintenance
Annual checking and servicing of the appliance and flue by a competent engineer is
recommended.
3.1.7 Ventilation
Adequate ventilation is ESSENTIAL for the safe and efficient operation of any solid fuel
or wood burning appliance. Ventilation MUST be provided where required by the stove
output or flue under-performance. Keep all ventilation clear and free of blockage. SEE
VENTILATION in INSTALLATION section.
Health And Safety Precautions
Special care must be taken when installing this stove to meet all requirements of
the Health & Safety at Work act.
3.1.8 Handling
Adequate facilities must be available for unloading and site handling. Cast Tec Stoves
are very heavily built so always ask for assistance when lifting and siting the stoves.
3.1.9 Fire Cement
Some types of fire cement are caustic and should not be allowed to come into contact
with the skin. In case of skin contact, wash immediately with plenty of water.
3.1.10 Asbestos
This stove contains no asbestos. If there is a possibility of disturbing any asbestos in the
course of installation then please seek specialist guidance and use appropriate
protective equipment.
3.1.11 Metal Parts
When installing or servicing this stove, proper care should be taken to avoid the
possibility of personal injury.
4.0 Installation Information
4.1 Chimney
The chimney height and the position of the chimney terminal should conform to Building
Regulations. Minimum chimney height is 4.5m. Check that the chimney is in good
condition, dry, free from cracks and obstructions. The diameter of the flue should not be
less than 150mm and not more than 200mm. If any of these requirements are not met,
the chimney should be lined by a suitable method. The chimney must be swept before
connection to the stove.
Where the chimney is believed to have previously served an open fire installation, it is
possible that the higher flue gas temperature from the stove may loosen deposits that
were previously firmly adhered, with the consequent risk of flue blockage. It is therefore
recommended that the chimney be swept a second time within a month of regular use
after installation.
If you have any doubts about the suitability of your chimney, consult your local
dealer/stockist or chimney specialist. If there is no existing chimney then either a solid
