Cassese CS969, Руководство пользователя и каталог запчастей

Страница: 31 / 81

USER MANUAL CS969
31
compulsory between the two actions. After 3 seconds, the buttons must be released and the operation repeated in the
same order so that a new cutting cycle is activated.
After cutting, if the off-cut or remaining piece of moulding does not drop under gravity into the off-cut tray and cannot be
retrieved outside the cover, it must be removed by pushing with the next moulding or a stick. It is strictly forbidden to cut several
lengths of moulding at the same time by stacking them or placing them one in front of the other.
When the machine is working, the workstation must not be occupied by more than one person. This person is
responsible for the controls.
The sawing operation (blade feed) is only possible once the horizontal and vertical pneumatic clamps are activated and
the saw blades are rotating.
If one of the buttons is released during cutting, the blade retracts and the buttons must be released to restart the cycle.
In the event of an accidental cut of the electrical circuit, the blade retracts immediately. When the electrical power returns, the
motors will not start until control button 4 is pressed (CP page 28 ).
In the event of an accident, press the red thrust button 5 (CP page 28 ) immediately to stop the blades and, before
taking any other action, switch off the power supply by setting the electrical contactor to the OFF position and lock with padlock
(see page
28
).
MEASURING THE FIRST PIECE (MOBILE STOP)
7.F.a Measuring the rebate (internal)
Slide the Cursor along the rule and lock it at the required dimension by tightening the locking screw. Bring the moulding to the
cursor so that the edge of the rebate coincides with the 45°angle.
Figure 7-5
Rule
Figure 7-6
Reading Point
Figure 7-7
Locking Screw
Figure 7-8
Mobile stop Locking handle
Figure 7-9
Cursor