Cassese CS 960, Инструкция по эксплуатации

Страница: 13 / 17

SETTING THE VERTICAL CLAMPS
(OPTION)
After releasing the handle (M2), position the vertical clamp positioning arms (BP) according to
the profile and the width of the moulding.
Apply the clamps by lifting your foot from the pedal, checking that the clamp pressor does not tilt
the moulding. The back of the moulding must be flat against the stops and its base on the work
table. To guarantee high quality cutting and safe operating conditions the moulding must be
immobilised throughout the operation.
Repeat the test under the same conditions for the right clamp.
The measurement obtained
after setting the left vertical clamp can be set on the rule of the right vertical clamp.
M2
BP
MEASURE
MEASURE
LEFT VERTICAL CLAMP
RIGHT VERTICAL CLAMP
1 st CUT ( preparing the moulding )
The moulding must have a fresh mitre cut before starting the measuring operations.
IMPORTANT:
When the cut is made, the right clamp must always be in contact with the
bottom of the slot and never press against the cut part of the moulding. If the latter is the
case, loosen the handle of the right horizontal clamp and move it back. Only the left hori-
zontal clamp will be used for clamping.
Once setting of the horizontal and vertical (option) clamps is complete:
- Unlock button 5.
- Lift your foot from the pedal.
- Press button 4 on the control panel (to start the blades).
- Press button 2 continuously with a finger of your right hand. This releases the left blade.
- Grip the arm of the left blade carriage with your left hand and pull the blade slowly
towards the clamped profile. Make the cut through to the front stop.
- Release button 2 and the blade carriage arm (which will return automatically to the back
position).
- Press button 5 to stop the machine.
- Press the pedal: the clamps move to unclamped position.
- Slide the moulding, pushing it from the left table to the right table.
1
2
3
4
5
8