Cassese CS 960, Инструкция по эксплуатации

Страница: 12 / 17

CONTROL PANEL
MACHINE
POWER ON
STOP
BLADES
UNLOCK RIGHT
BLADE
UNLOCK LEFT
BLADE
START
BLADES
When the air supply is switched on, the clamps move to CLAMPING posi-
tion. When the pedal is pressed the clamps are released.
PEDAL FUNCTION
1 2
3 4
5
SETTING THE HORIZONTAL CLAMPS
SWITCH ON THE MACHINE
. Place the bead on the work table presenting it from the left of the
machine (slot side facing the saw blades and pressing against stops BD - BG).
Press the pedal: the clamps move to
UNCLAMPING
position.
Keep the pedal pressed with your foot throughout setting
.
Release the left clamp handle (M) and move the pressor to roughly 1 cm from the profile edge,
then retighten handle M. Repeat the operation for the right horizontal pressor (for preparatory
cut see next page 8 -
1st CUT ).
CLAMPING
UNCLAMPING
PEDAL PRESSED PEDAL RAISED
M
1 CM
7
V - SAWING
FITTING THE LEFT AND RIGHT
ARMS OF THE CARRIAGE
Open the removable panel at the rear of the machine, after
unscrewing the 4 screws (5-mm Allen key). Fix the left arm to
the blade carriage using screws V1 and V2 (6-mm Allen key).
Repeat the operation for the right arm. Close the rear panel
(compulsory).
V1
V2