Cassese CS 960, Инструкция по эксплуатации

Страница: 11 / 17

IV - STARTING UP
MAIN ISOLATING SWITCH
- Open the compressed air source (4 bar: factory setting).
- Switch on the machine: main isolating switch at top right of
the machine (see CS 960 description page A).
Indicator lamp 3 (see Control panel, page 7) lights.
This indicator only lights when the CS 960 is energised.
PRESSURE
REGULATING
VAVLE
Unlock button 5 then press button 4 (see Control panel, page 7).
Check the direction of rotation of the two blades, i.e.:
- clockwise for the left blade,
- anti-clockwise for the right blade.
If the direction is not correct, press button 5 (see Control panel, page 7), disconnect the machine and reverse the
two phases of the power supply cable.
1
2
Use a supply hose of inner dia. 8 mm withstanding the maximum pressure of the source, which
must not be less than 4 bar. Source characteristics: dry, non lubricated air.
Electrical connection
The user must connect the power supply cable to a source complying with the regulations in
force and protect the machine by fitting fuses: 25 Amp aM for 220 Volt single-phase and 16
Amp aM for 380/220 Volt 3-phase.
To conform to hygiene standards, the machine must be connected to an
extraction system producing a maximum flow rate of 28 m
3
/second over
a diameter of 100 mm. The circuit comprises 2 nozzles 100 mm in
diameter at the rear of the machine. This installation guarantees effective
extraction and must never be dismantled or modified.
Pneumatic connection
Dust extraction
USA FITTING
COMPRESSOR
SAW PRESSURE
REGULATING
VALVE
FEMALE QUICK-FIT
CONNECTOR
Z 675
Z 749
Z 701
Z 556
STANDARD
BARBED
FITTING
Pedal connection
Connect the pedal as follows:
-
BLUE TRANSPARENT
tube in
position
1
-
RED
tube in position
4
-
BLUE
or
CLEAR TRANSPARENT
tube in position
2
2
3
5
4
1
BLEU
RED
TRANSPARENT
OFF
ON
2
BLUE
MD
6